Dialogic SS7G2X - Manual (Page 62)

62
Chapter 6 Command Definitions
6.5.23 CNTSP – Configuration Timeslot Print
Synopsis
This command is used to print the configuration of all timeslots on a PCM .
A timeslot on a PCM can be allocated to signaling, voice, cross connect, monitoring or it can be unallocated.
Data is printed for a timeslot when it is acting as an outgoing timeslot.
A timeslot can act as an outgoing timeslot for the following types:
•
SIG - Carries signaling information. It forms a duplex connection.
•
OTS - Acts as an outgoing timeslot for a cross connection. It may form a duplex connection.
•
STS - The outgoing timeslot monitoring the send direction of an object.
•
RTS - The outgoing timeslot monitoring the receive direction of an object.
Note: An object is currently only a signaling link.
For signaling, the STS monitors information sent from the EQU of the signaling link and the RTS monitors
information received by the signaling link.
Syntax
CNTSP: PCM =;
Prerequisites
None
Attributes
None.
Examples
CNTSP: PCM =3-3;
Output Format
PCM Timeslot Configuration
TS TYPE C7LINK ITS
3-3-22 SIG 6
3-3-24 OTS 4-4-4
3-3-25 RTS 7
3-3-25 STS 8
EXECUTED