Dialogic SS7G2X - Manual (Page 107)

107
Dialogic ® SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.12.1 SGDPI – Signaling Gateway Destination Point Initiate
Synopsis
This command initiates routing to a destination point identified by a routing key or incoming route.
Destination selection either selects an Application Server (AS) or attempts to route to the MTP or IP side on
a priority basis. If an Application Server is not configured, the Signaling Gateway attempts to find a route to
the Destination Point Code (
DPC ) of the received message over MTP or IP. The user can configure whether to
route the message via MTP or IP if the Point Code is available over both by setting the RTPRI parameter.
A destination can either be a route (MTP or IP or a combination of both) or a Application Server. If both MTP
and IP routes are specified, the default priority indicates which route to the Point Code should be selected
first if available. MTPONLY and IPONLY state that no attempt to other domain should be made if the routes
through these domains are unavailable.
Syntax
SGDPI: DEST =, RTPRI =,[ LABEL =,];
SGDPI: DEST =, AS =,[ LABEL =,];
Prerequisites
•
The destination point has not already been initiated.
•
An AS , if specified, must serve only 1 destination.
•
If an AS is specified, it must be initialized.
•
RTPRI cannot be set to NONE if an AS is not present.
•
NONE is the only value allowed for RTPRI if an AS is present.
Attributes
CONFIG
Examples
SGDPI: DEST =1, AS =1;
6.12.2 SGDPC – Signaling Gateway Destination Point Change
Synopsis
This command changes parameters on the Signaling Gateway destination point.
Syntax
SGDPC: DEST =,[ RTPRI =,][ AS =,][ LABEL =,];
Prerequisites
•
The destination point has already been initiated.
•
If an AS is specified, it must serve only one destination.
•
If an AS is specified, it must be initialized.
•
RTPRI cannot be set to NONE if an AS is not present.
•
NONE is the only value allowed for RTPRI if AS is present.
•
If an AS is specified, there cannot be any routing key in the system with a destination to this AS , not
having or not matching the NC / DPC parameters with the AS NC/DPC.
Attributes
CONFIG
Examples
SGDPC: DEST =1, AS =1;