Dialogic SS7G2X - Manual (Page 63)

63
Dialogic ® SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.5.24 CNUPI – Configuration Update Initiate
Synopsis
This command is used to update configuration data, software or a license on the Signaling Gateway. The
operation involves reading files containing either configuration data, software or a license from a Remote
Data Centre (if specified) or CD ROM and loading it into memory. Optionally, the file may be read from a
subdirectory (
DIRECTORY ) of the account on the RDC.
A FILE name should be entered on the command line without a suffix. The command automatically reads the
file name with a suffix. The command determines the suffix by use of the DTYPE parameter. For example, the
file CFG.CF3 for a DTYPE of CONFIG would be entered as CFG.
The filename suffix for DTYPE =CONFIG is .CF3.
The filename suffix for DTYPE =SOFTWARE is .tgz.
The filename suffix for DTYPE =LICENSE is .lic.
If not specified, the default filename for a DTYPE =CONFIG is “SDC”.
If not specified, the default filename for a DTYPE =SOFTWARE is “sgw”.
If not specified, the default filename for a DTYPE =LICENSE is “sgw”.
Note: During execution of this command, there system may not respond for up to 3 minutes while the
command is being executed.
Syntax
CNUPI: DTYPE =, RDC =,[ DIRECTORY =,][ FILE =,];
Prerequisites
•
If the RDC is specified, it should be initiated and not blocked.
Attributes
CONFIG
Examples
CNUPI: RDC =1, DTYPE =CONFIG, DIRECTORY =AUTH, FILE =CFG;