Dialogic SS7G2X - Manual (Page 110)

110
Chapter 6 Command Definitions
6.12.6 SGIRC – Signaling Gateway Incoming Route Change
Synopsis
This command changes the configuration of a Signaling Gateway incoming route.
For RKTAB / DEST , a value of “null” is supported. “null” indicates a wildcard value and means any value. “null”
is the default value for an RKTAB/DEST entry.
Note: The value “null” cannot be used for these parameters elsewhere in the system unless explicitly
specified in the command.
Syntax
SGOPC: IR =,[ RKTAB =,][ DEST =,][ LABEL =];
Prerequisites
•
The incoming route already exists.
•
If specified, the destination index exists.
•
The NC / DOMAIN combination has already been initiated.
•
Either an RKTAB or DEST must exist.
Attributes
CONFIG
Examples
SGIRC: IR =1, DEST =5;
6.12.7 SGIRE – Signaling Gateway Incoming Route End
Synopsis
This command ends the configuration of a Signaling Gateway incoming route.
Syntax
SGIRE: IR =;
Prerequisites
•
The incoming route already exists.
Attributes
CONFIG
Examples
SGIRE: IR =1;