Aiwa NSX-999 - Manual (Page 66)

KARAOKE
MIO bCHO-
_.
....
4#
::i
■ '7' S
JJ.' I
■niGITAI.
FCHO
DECK 1 ? DAND
TAPE J ^UNER^ [VIDEOW^ CD
J
MIC
MIXING
MICROPHONE MIXING
t * - 4 —a ------^1 -T
■ I M
ttJt 1
. —'■ ; ^ *
2
3
4
Up to two microphones can be connected to this unit, ailowing you
to sing aiong to music sources.
Use a microphone with a mini (e3.5 mm/Ve inches) piug.
Before connecting a microphone
Set the MIC MIXING control to MIN.
1 Connect your microphone(s) to the MIC jack(s).
source to be mixed, and play It.
3 Adjust the volume and tone of the source.
4 Adjust the microphone volume.
You can adjust the volume of the microphones connected to the
both of the MIC jacks by the MIC MIXING control at the same
time.
To record microphone sound mixed with source sound
Insert a tape in the deck 2, and press the • REC/REC MUTE
button. You can record while using the echoing effect, VOCAL
FADER, MULTIPLEX or BBE function.
When not using the microphone
Set the MIC MIXING and DIGITAL ECHO control to MIN and
remove the microphone(s) from the MIC jack(s).
NOTE
• If the microphone is held too near the speakers, a howling sound
may be produced. In this case, hold the microphone away from
the speakers, or decrease the sound level using the MIC MIXING
control.
♦ If sound through the microphone is extremely loud, it may be
distorted. In this case, turn the MIC MIXING control toward MIN.
When connecting two microphones simultaneously
The use of unidirectional type microphones (Aiwa DM-H18, DM-
H15, etc.) is recommended to prevent howling.
DIGiTAL
ECHO
C
MiC ECHO
MIN MAX
S' S.-c'S
i i t\ I
I I I \l
ECHOING THE SOUND □
You can get an echo sound while using the microphone.
First, press the MiC ECHO button to dispiay “E-ON”. Then, adjust
the echo voiume with the DIGITAL ECHO control.
To cancel the echoing effect
Press the MIC ECHO button twice to display “E-OFF”.
NOTE
• If the MIC ECHO is set to OFF, the echoing effect cannot be
obtained, though the DIGITAL ECHO control is set to MAX.
• If you select the DSP mode, the MIC ECHO will be set to OFF
automatically.
When the MIC ECHO is set to ON, the selected DSP mode is
automatically canceled.
66