Recording from the radio or connected equipment, Preparation, 1 insert the tape to be recorded on into deck 2 – Aiwa NSX-999 User Manual
Page 46: 2 set dolby nr, 3 set the reverse mode, To stop recording, To pause recording, To insert 4-second blank spaces, 2 press the ii button to resume recording, To insert a blank space of more than 4 seconds
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RECORDING
I I
1
1
DOLBY NR
NR
0 n 00
T f ^ P E E
BAND
c
TUNFR
VIDEO.AUX
iwl
I I I
REC/REC MUTE
rRECl
■
( (
I - I t
u. U UWM
L Ivi
I I I
((^
s___ __ ^____
iLf. - - .U4. ■■
^5-------------- II —^ »_i u U L.t ..............................................
J ' T n O C J
----- ------ ^ ' / ! / / _ / _
3
REV MODE
(DECK/2)
4.
6
r f i P E O
RECORDING FROM THE RADIO OR
CONNECTED EQUIPMENT
Preparation
• Wind up the tape to the point where recording wiil start.
• Use normal (type I) or CrOa (type n) tapes.
1 Insert the tape to be recorded on into deck 2.
Press the EJECT ± mark to open the cassette holder.
Insert the tape with the side to be recorded on first facing you
and the exposed side down.
Push the cassette holder to close it.
2 Set DOLBY NR.
To record with DOLBY NR; Press the DOLBY NR button to turn
on the Dolby NR. The □□ NR indicator will light.
To record without DOLBY NR: Press the DOLBY NR button to
turn off the Dolby NR. The □□ NR indicator will go off.
3 Set the reverse mode.
Each time the REV MODE button is pressed, the reverse mode
changes.
To record on one side only, turn on —.
To record on both sides, turn on lO.
4 Press the TUNER/BAND or VIDEO/AUX button to
select the source to be recorded from and play it.
5 Press the • REC/REC MUTE button to start record
ing.
When you use the remote control to start recording, first press
the e/O REC/REC MUTE button and then press the
button within 2 seconds.
To stop recording
Press the ■ button.
To pause recording
Press the II button.
To resume recording, press it again.
TO INSERT 4-SECOND BLANK SPACES
Blank spaces in the recording allow you to activate the Music
Sensor function (see page 38). (Applicable when the source is
TUNER or VIDEO/AUX.)
1 Press the • REC/REC MUTE button during record
ing or from recording pause mode.
REC flashes in the display for 4 seconds and the tape runs
without recording. After 4 seconds the deck enters recording
pause mode.
2 Press the II button to resume recording..
To insert a blank space of less than 4 seconds
After pressing the • REC/REC MUTE button, press it again while
REC is blinking to resume recording.
To insert a blank space of more than 4 seconds
After the deck enters recording pause mode, press the • REC/
RECMUTE button again. Each time it ispressed,a4-second blank
space is added.
46