Aiwa NSX-999 - Manual (Page 38)

TAPE PLAYBACK
BASIC OPERATIONS
To fast forward or rewind
In stop mode, press the ◄◄ DOWN or ►► UP button.
To stop fast fonward or rewind, press the ■ button.
To Change the playback side
During play or in pause mode, press the DIRECTION/
PRESET button.
Each time the button is pressed, the piayback side changes.
To set the selected tape counter to 0000
In stop mode, select a deck by pressing the TAPE/DECK1/2
button, then press the ■ CLEAR button. The selected counter is
set to 0000.
The counter is also set to 0000 when a cassette holder is opened.
Usable tapes
Use normal (type I), CrOa (type II) or metal (type IV) tapes.
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance, press the DOLBY NR button to turn the
□□ NR indicator on when a tape recorded with the DOLBY NR
system is played back.
NOTE
Noise may be heard if a television set is on nearby. Turn off the
television or separate the television from this unit.
CONTINUOUS PLAY
After playback on one deck finishes, the tape in the other deck will
start to play without interruption.
1 Insert tapes into deck 1 and 2.
2 Press the TAPE/DECK 1/2 button to select the deck to be
played back first.
3 Press the REV MODE button and select TO.
4 Press the button to start playback.
Playback continues until the ■ button is pressed.
■a-
.‘f.’
-A -■
, .
SEARCHING FOR THE BEGINNING OF A
TRACK
(MUSIC SENSOR FUNCTION)
If there is a 4-second or longer blank between each track, you can
search easily for the beginning of a track during playback.
The search can be made in the fonward or reverse direction.
According to the direction of the lighted indicators on the
DIRECTION/PRESET button, press the ◄◄ DOWN or ►► UP
button during playback to move to the next track or play the current
track.
Refer to the table for search directions. -♦ □
® DIRECTION/PRESET button indicators
d) The button you press to move to the next track
d) The button you press to play the current track
(D
►► M M
^ I ^
M M
_ _ _ _ _ dO________
38
NOTE
The search function uses a music sensor, which may not be able
to detect tracks for tapes with
• blanks of less than four seconds between tracks.
• noisy blanks.
• long passages of low-level sound.
• low overall recording levels.