YSI 5200A User Manual

Page 16

YSI 5200A

1. See Open Front Panel to Access I/O Board - page 38 to remove front

panel from 5200A enclosure.

Figure 3.4

2. Disconnect front panel ribbon cable by pressing the two IDC header

connectors located on the front panel out (away from the IDC header)

- figure 3.5.

Figure 3.5

Installation and Wiring

3. Remove and retain the four screws that secure the display board into front

panel enclosure - figure 3.6. (The display board is mounted on panel that

is attached to 5200A front panel. The I/O Board wiring diagram is located

on the display board panel.)

figure 3.6

4. Carefully lift out the display board and remove the lanyard from the display

board panel - figure 3.7. Set display board panel and front panel aside.

Figure 3.7

5. Fasten the mounting brackets to the back of the 5200A enclosure with the

mounting screws - figure 3.2, page 28.

6. Tighten the screws, securing the brackets to the 5200A.

7. Drill a hole in the panel for 5200A enclosure (dimensions provided with

kit).

Installation and Wiring