YSI 5200A - Manual (Page 102)

YSI 5200A
203
YSI 5200A
202
Menu Map Key
The following conventions are used in menu maps:
- Factory defaults are contained in ( ). If blank, no default value is loaded for
this menu. In certain menus, the user configuration will appear in () once the
menu is configured.
- System range (if applicable) are in italics; “*” displayed after the range indi-
cates that the range is based on another system configuration i.e. set point
submenus.
- (Not Available) indicates hardware is not installed or menu is not applicable
to system configuration.
The following graphics are used in menu maps:
- 7
- Input is required at numeric or alpha/numeric keypad.
- - display of softkey indicates selection of softkey is re-
quired.
- q - Make a selection from a pull down menu.
- - Use three front panel key to proceed; (only used at adjust contrast
menu).
Menu Maps Menu Maps
The menu map below depicts how the menu map conventions and graphics are
used for configuring the DO alarm low value and enabling the DO system alarms.
(complete DO menu is not shown in example)
MENU MAP EXAMPLE