Solvline Eddy DKV2.1.0.3 - Manual (Page 78)

Chapter 5.
Creating Firmware
78
Firmware will be created in ‚FIRMWARE_DIR‛ directory defined in Makefile.
On Windows, use cmd(command prompt) to carry out procedures explained on Linux.
[shlee@localhost ramdisk]$ make release
.
.
[shlee@localhost ramdisk]$
make install
.
.
[shlee@localhost ramdisk]$ ls ../firmware
-rwxr-xr-x -----------------------------------------eddy-bl-2.1.x.x.bin
-rwxr-xr-x -----------------------------------------eddy-bs-2.1.x.x.bin
-rwxr-xr-x -----------------------------------------eddy-os-2.1.x.x.bin
-rwxr-xr-x -----------------------------------------
eddy-fs-2.1.x.x.bin
.
.
As shown in the picture above, a new firmware file ‚eddy-fs-2.1.x.x.bin‛ has been created. Now
you have to upload the firmware image to Eddy via Web or FTP, save it to Eddy’s flash memory,
and reset Eddy. Then Eddy will run as the loaded firmware settings.
5.2 Firmware Upgrade
Upload created firmware file to Eddy and save on the Flash Memory.
Eddy provides four ways of upgrading method.
FTP
Upload a firmware image using FTP program, and execute the
upgrade command to save it to the Flash memory using Telnet.
Web Browser
Connect to Web server of Eddy and save a firmware to the Flash
memory.
Please refer Eddy_User_Guide for detail information.
Boot Loader
Use the boot loader which operates on booting to save a
firmware through the debugging port of Eddy DK board.
Please refer ‚the chapter 9: System Recovery‛ for detail.
USB
Use USB client port of Eddy DK board to upload a firmware.
Please refer ‚the chapter 9: System Recovery‛ for detail.
This section explains how to upload a firmware using a FTP.
On Windows, FTP can be used in cmd(command prompt) to carry out upload process.
Upload the created firmware, ‚eddy-fs-2.1.x.x.bin‛, to the /tmp directory of Eddy, using an FTP.