Solvline Eddy DKV2.1.0.3 - Manual (Page 118)

Chapter
9. Appendix
118
3) If you get as below log file, you need to check the S6 dip switch. It should be pulled
up.
or S1 dip switch is Eddy-S4M
9.3 Product Specification
9.3.1 Eddy CPU v2.1 Specifications
Item Classification Specification
Hwrdware
CPU ARM926EJ-S (210 MHz)
Memory 8MB Data Flash, 32 MB SDRAM
External I/F 19 Bit / 16 Bit Data Bus
Ethernet I/F 10/100 Base-T Auto MDI/MDIX
UARTs
4 Port, Support up to 921.6 Kbps
(1 : Full Signal, 2,3,4, : RxD, TxD, RTS, CTS only)
USB 2.0 FS 2 Host /1 Device Port, 2.0 FS (12Mbps)
ADC 4-Channel 10 Bit ADC
TWI(I2C) Master, Multi-Master and Slave Mode
SPI
8- to 16-bit Programmable Data Length
Four External Peripheral Chip Selects
GPIO Max. 56 Programmable I/O Pins
Power Input 3.3 V (200 mA Max)
Dimensions 25 x 48.5 x 6.2 mm
Weight 8.3 g
Network Protocol
TCP, UDP, Telnet, ICMP, DHCP, TFTP, HTTP, SNMP 1&2,
SSH, SSL
-I- Waiting ...
-E-
Connection \usb\ARM0 not found
-E- Connection list : COM2 COM3 COM4 COM5
…
-I- Loading applet isp-dataflash-at91sam9260.bin at address 0x20000000
-E- Script File Eddy_burning_DataFlash.tcl returned error : Error Initializing DataFlash
Applet (Can't detect known device) - Error Initializing DataFlash Applet (Can't detect
known device)
while executing
"error "Error Initializing DataFlash Applet ($dummy_err)""
(procedure "DATAFLASH::Init" line 13)
invoked from within
"DATAFLASH::Init 1 "