System recovery via usb, Firmware upgrade utility program, Installing upgrade utility program – Solvline Eddy DKV2.1.0.3 User Manual
Page 112: 2 system recovery via usb
Chapter
9. Appendix
112
9.2 System recovery via USB
Even if the flash in the user area has been damaged, it does not affect system booting. But if the
system continuously reboots due to user program failure, or if the system is inaccessible as a result of
wrong IP setting, you have to change the system to factory default status.
You can reload firmware via USB to change the system to default status.
9.2.1 Firmware Upgrade Utility Program
The AT91 ISP can be downloaded from the ATMEL Web site at the following URL:
If the URL does not work properly,
Go to the ATMEL homepageClick Product > Microcontrollers > AT91SAM 32-bit ARM-based Microcontrollers > Tools & Software
> Evaluation Kit > AT91SAM9260-EK > AT91-ISP.exe (v1.12 current release)
9.2.2 Installing Upgrade Utility Program
The AT91 ISP can be downloaded from the ATMEL Web site at the following URL:
If the URL does not work properly,
Double-click ‚AT91-ISP.exe‛ file and
begin the installation process,
then click Next.