beautypg.com

Reznor UEAS Unit Installation Manual User Manual

Page 3

background image

1.2 General

Information

WARNING

Do not use this appliance if any part has been under

water. Immediately call a qualified service technician to

inspect the appliance and replace any gas control that

has been under water.

WARNING

Installation should be done by a qualified agency in

accordance with these instructions. The qualified

service agency installing this high efficiency separated-

combustion system is responsible for the installation.

1.3 Warranty

Refer to the limited warranty information on the Warranty Form shipped with the

heater.

Warranty is void if ...

a. Wiring is not in accordance with the diagram furnished with the heater.
b. The unit is installed without proper clearance to combustible materials.
c. A fan model is connected to a duct system or if the air delivery system is

modified.

1.4 Installation Codes

These units must be installed in accordance with local building codes. In the

absence of local codes, in the United States, the unit must be installed in accor-

dance with the National Fuel Gas Code, ANSI Z223.1 NFPA 54. A Canadian instal-

lation must be in accordance with the CSA B149 Installation Codes. These codes

are available from CSA Information Services, 1-800-463-6727. Local authorities

having jurisdiction should be consulted before installation is made to verify local

codes and installation procedure requirements.
Installations in aircraft hangars should be in accordance with ANSI/NFPA No. 409

(latest edition), Standard for Aircraft Hangars; in public garages in accordance

with ANSI/NFPA No. 88A (latest edition), Standard for Parking Structures; and for

repair garages in accordance with ANSI/NFPA No. 88B (latest edition), Standard

for Repair Garages. In Canada, installations in aircraft hangars should be in accor-

Model UEAS high-efficiency unit heaters are design certified by ITS for use in

industrial and commercial installations in the United States and Canada. Instruc-

tions in this manual apply only to Model UEAS heaters.
Model UEAS heaters are available for use with either natural or propane gas. The

type of gas, the input rate, and the electrical supply requirement are shown on the

heater rating plate. Check the rating plate to determine if the heater is appropriate

for the intended installation.

NOTE: All Model UEAS heaters are factory equipped

for use with natural gas and include a conversion kit for field conversion for use

with propane.
Model UEAS heaters have a titanium stabilized primary heat exchanger with a

MacroChannel

®

secondary heat exchanger.

CAUTION

Model UEAS unit heaters should not be used in an application

where the heated space temperature is below 50°F. The

combination of low space and combustion air temperatures

may result in condensate freezing in the secondary heat

exchanger and/or condensate drain.

Special Installations

(Aircraft Hangars/

Repair Garages/Parking

Garages)

Form I-UEAS, P/N 221232 R13, Page 3