Cabletron Systems Expansion module 6H122-08 - Manual (Page 82)

Chapter 5: Local Management
5-38 6H122-08 User’s Guide
Figure 5-17 Module Configuration Menu Screen
The following briefly explains each screen accessible from the Module
Configuration Menu screen:
GENERAL CONFIGURATION
The General Configuration screen allows the user to monitor and
configure operating parameters for the 6H122-08. For details, refer to
Section 5.15 .
SNMP COMMUNITY NAMES
The SNMP Community Names screen allows the user to enter new,
change, or review the community names used as access passwords for
Local/Remote management operation. Access is limited based on the
password level of the user. For details, refer to
Section 5.16 .
SNMP TRAPS
The SNMP Traps screen provides display and configuration access to the
table of IP addresses used for trap destinations and associated community
names. For details, refer to
Section 5.17 .
Firmware Revision: XX.XX.XX
Module Configuration Menu
GENERAL CONFIGURATION
SNMP COMMUNITY NAMES
SNMP TRAPS
SWITCH CONFIGURATION
ETHERNET INTERFACE CONFIGURATION
SMARTTRUNK CONFIGURATION
MODULE SPECIFIC CONFIGURATION
2159-15
BOOTPROM Revision: XX.XX.XX
Module Type: 6H122-08
Slot Number: X
6H122-08 LOCAL MANAGEMENT
Event Message Line
RETURN EXIT