Cabletron Systems Expansion module 6H122-08 - Manual (Page 53)

Accessing Local Management
6H122-08 User’s Guide 5-9
5.4 ACCESSING LOCAL MANAGEMENT
Access to Local Management is controlled through the Password screen,
Figure 5-3 . Whenever a connection is made to the 6H122-08 the
Password screen displays. Before continuing, the user must enter a
password which is compared to the previously stored passwords. The
level of access allowed the user depends on the password. To set or
change passwords refer to
Section 5.8 . The following steps describe the
procedure to access Local Management.
1. Turn on the terminal. Press ENTER (this may take up to four times,
because the COM port of the 6H122-08 auto-senses the baud rate of
the terminal) until the 6C105 Local Management Password screen,
Figure 5-3 , displays.
Figure 5-3 The Local Management Chassis/Module Password Screen
2. Enter the Password and press ENTER. The default Super-User access
password is “public” or press ENTER.
NOTE
The User’s password is one of the community names specified
in the SNMP Community Names screen. Access to certain
Local Management capabilities depends on the degree of
access accorded that community name. Refer to Section 5.8.
6C105 LOCAL MANAGEMENT
CABLETRON Systems, Incorporated
P.O.Box 5005
Rochester, NH 03866-5005 USA
(603) 332-9400
(c) Copyright CABLETRON Systems, Inc, 1997
Enter Password:
2159-12
Event Message Line