Juniper Systems LandMark Mobile - Manual (Page 63)

LandMark Mobile User’s Manual 6
LandMark Mobile Configuration Screen Error Messages
The following are the error messages and suggested fix for those
messages that may occur when using the LandMark Mobile
Configuration screen.
Error message:
Parameter file is write protected! Parameter cannot be changed.
Message appears when a you try to change the configuration
settings. Changes cannot be made for the following reason:
1. The Ini File Write Protected box has been checked by the
programmer.
If parameter changes need to be made, the programmer must
uncheck the Ini File Write Protected box. See Programming
chapter for details on how to do this.
Error message:
Datum not defined. Using WGS84 (Default Datum).
You can change the Datum in the lm.ini file outside of LandMark
Mobile (i.e. a third party application). When LandMark Mobile
starts up, it checks if the lm.ini datum value is valid. The error
message appears for one of the following reasons:
1. The current datum used is the default WGS84.
2. When any of the three datum files are corrupt.
Fix the problem by fixing the lm.ini file, doing a reset, or
reinstalling LandMark Mobile.
Error message:
Cannot change this option through the application. Please read the
manual for details.
When you try this to check the Ini File Write Protected box found
in the File Tab within the configuration settings, this error
message appears for the following reason:
1. The Ini File Write Protected box must be enabled by a
programmer in the ini file source code.
See the Programming chapter for more information.