Juniper Systems LandMark Mobile - Manual (Page 61)

LandMark Mobile User’s Manual 61
Error message:
Failed to open waypoint file and create the converted file.
This error message appears for the following reason:
1. A waypoint file conversion fails at the beginning of the
process because the waypoint file could not be accessed.
Fix the error by doing either a reset or by deleting old files to free
up disk space.
Error message:
Failed to create the converted file.
This message pops-up when trying to either create a new
converted file or write data to a newly converted file. This
message appears for one of the following reasons:
1. The disk is full.
2. The file is already open in another application.
To fix the error, delete some files off of the storage disk or close
the file being used by the other running application.
Error message:
Could not create shared memory. Method stopped.
The error message appears for the following reason:
1. An error reserving shared memory has occurred.
To fix the error do a reset and restart LandMark Mobile.
LandMark Mobile Mark Point Screen Error Messages
The following are the error messages and suggested fix for those
messages that may occur when using the LandMark Mobile Mark
Point screen.
Error message:
Waypoint name can be 0 characters or less. Characters after 0 will
be truncated.
When naming a point, this message appears for the following
reason:
1. The waypoint name is too long and needs to be shortened.
To fix the problem, shorten the point name to less than 30
characters.