Juniper Systems LandMark Mobile - Manual (Page 57)

LandMark Mobile User’s Manual 5
Could not find Ellipse.dat file.
Ellipse.dat files are datum files saved in the registry. This error
message appears for one of the following reasons:
1. The registry is corrupt, or a clean boot was executed.
2. The program path was modified, so the registry path is no
longer available.
3. The ellipse.dat files were deleted.
To solve the problem, check the registry path. Registry errors
may be fixed by doing a reset. If the reset does not work, reinstall
LandMark Mobile.
Error message:
Error Initializing WMM2K - WMM.COF File not found.
WMM is a formula used to calculate magnetic declination from
GPS data. Most receivers do this calculation, but some do not. In
the instance that a receiver does not calculate magnetic declination,
you need to use either Manual Mode, or WMM 2K for calculations.
The error message appears if the WMM.COF file cannot be found.
The following are reasons for not being able to find the file:
1. The registry is corrupt, or a clean boot was executed.
2. The program path was modified, so the registry path is no
longer available.
3. The WMM.COF file was deleted.
4. The date setting on the Field PC precedes the year 2005.
Registry errors may be fixed by doing a reset. If the reset does not
work, reinstall LandMark Mobile.
Error message:
lm.ini File not found - Default values used.
The lm.ini file is where LandMark Mobile’s specifications are
written. This message appears for one of the following reasons:
1. The registry is corrupt, or a clean boot was executed.
2. The program path was modified, so the registry path is no
longer available.
3. The lm.ini file was deleted.
Registry errors may be fixed by doing a reset. If the reset does not
work, reinstall LandMark Mobile.
Error message: