Juniper Systems LandMark Mobile - Manual (Page 33)

LandMark Mobile User’s Manual
Compass
The compass is shown on the left side of the screen. The compass
rotates to show the direction of travel when you start moving. It is
updated when your speed is greater than 0.5 km/hr (0.31 mph).
The arrow is fixed and always points toward the To location
and assumes the direction of travel is the top of the screen. The
compass body rotates to show the current direction of travel, as
long as you are moving. When you stop, the top of the compass
points to the north.
Here -> To
The Here -> To section of the Navigation screen, shown on the
upper right, displays calculated values based on the current GPS
location (Here) and the destination (To) location.
Distance
The Distance box displays the distance in the selected current
units (meters or feet) from the Here to the To location.
Bearing
The Bearing box displays the compass heading in degrees from
Here to the To location.
Track
The Track box displays the direction you are traveling in degrees.
Speed
The Speed box displays the speed you are moving in current
display units (km/h or mph).
XTE
The XTE box gives the shortest distance between the current
location of the GPS receiver and the line that connects the From
and To locations. A positive (+) XTE is to the right of the path
and a negative (-) XTE is to the left, assuming you are traveling
toward the To location.
From -> To
The From -> To section of the Navigation screen displays calculated
values based on the From location to the To location. When
changing From or To waypoints, displayed information in the
Here -> To section may not be updated until you start moving; this
can depend on the GPS receiver being used.