Futaba 3PKS - Manual (Page 73)

73
F
u
nction
Boat Mode "BOAT"
(Preparation)
- Use the function select dial function to select the 3rd channel
operation dial. (page 80)
1
(Function ON/OFF)
Select the setting item "MODE" by (JOG) button up or down
operation. Set the function to the "ON" state by pressing the
(+) or (-) button.
"INH" :Function OFF
"ON" :Function ON
2
(CH1>CH3 mixing amount adjustment)
Select setup item "CH1>3" by (JOG) button up or down op-
eration, and use the (+) and (-) buttons to adjust the mixing
amount.
"+" :Operate in same direction as steering
"-" :Operate in opposite direction of steering
3
(CH1>CH1 mixing amount adjustment)
Select setup item "CH3>1" by (JOG) button up or down op-
eration, and use the (+) and (-) buttons to adjust the mixing
amount.
"+" :Operate in same direction as channel 3
"-" :Operate in opposite direction of channel 3
4
When ending setting, return to the initial screen by pressing
the (END) button twice (for direct selection, press the (END)
button once).
Tilt mixing adjustment
The mixing rate amount can be controlled with digital dial DL1, DL2, DL3 or digital
trim DT3, etc. with the function select dial function. (Page80)
Dial / Trim Setting
Steering > 3rd channel side : +100%
3rd channel > Steering side : -100%
Slave channel output (Initial value)
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Mixing amount (CH1>3)
-100~+100
Initial value: +100
Mixing amount (CH3>1)
-100~+100
Initial value: -100
Function ON/OFF (MODE)
INH(OFF), ACT(ON), ACT(OFF)