Futaba 3PKS - Manual (Page 18)

ｉ Caution
18
B
e
fo
re
Using
Ni-cad Battery Replacement
The Ni-cad battery is connected by a connector so that it can be removed when you will
not be using the transmitter for a long time, or when replacing a dead battery with a
spare battery.
• Always use an NT8F7000B Ni-cad battery.
Ni-cd battery
NT8F700B
Removal
1
Slide the transmitter battery cover in the ar-
row direction while pressing the part shown
in the figure.
2
Remove the Ni-cad battery and disconnect
the connector.
Battery cover
While pressing here Battery cover
Charging
1
Plug the transmitter cord of the special char-
ger into the charging jack on the rear of the
transmitter.
2
Plug the charger into an AC outlet.
3
Check that the charging LED lights.
AC outlet
Charger
Transmitter charging
LED
Cord to transmitter
charging jack
Charging the Ni-cad Battery
ｅ Pay full attention so that the battery cover wouldn't pinch the cable
of the Ni-cad battery.
Pinching the cable by the battery cover can lead to an electrical shortage, fire and
abnormal heat generation, which may cause burns and fire disaster.