Futaba 3PKS - Manual (Page 43)

43
F
u
nction
(Opening Screen)
MENU 1
Press t he button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t he button
* When the direct call button is set,
the setup screen is also called by the
following method:
•Select the setting item by
button
* b l i n k s a t t h e c u r r e n t
setup item.
Servo Reverse "REV"
However, when the position set by trim or subtrim shifts from
the center, the center becomes the opposite side.
Normal side
Revers side
Servo Reverse "REV" (All channel)
This function reverses the direction of operation of the servos related to transmitter
steering, throttle, and channel 3 operation.
(Preparation)
Select the channel to be set by (JOG) button left or right op-
eration. ST, TH, and CH3 on the screen blink.
1
(Servo reverse setting)
Use the (+) or (-) button to reverse the servo operation direc-
tion.
(Each channel can be set similarly.)
2
When ending setting, return to the initial screen by pressing
the (END) button twice (for direct selection, press the (END)
button once).
Sevo Reverse Function Setting
Channel
ST :Steering
TH :Throttle
CH3 :Channel3
*Blinks at the current setup
channel.
Select button
- Select with the (+) or (-) but-
tons.
Channel selection
- Select by (JOG) button left or
right operation.