Futaba 3PKS - Manual (Page 68)

Steering operation
N N
E
E
DTY
Ser
v
o tr
a
v
el
DTY (duty): X and Y ratio
X: (Brake
application time)
Y: (Brake return time
68
F
u
nction
A.B.S Function "A.B.S"
When steering mixing is set and
steering operation enters the set
range, " " is displayed in front of
the number. When mixing is OFF,
the A.B.S function can operate
over the entire steering range.
6
(Cycle duty ratio setup)
Select setting item "DTY" by
(JOG) button up, down, left
or right operation. Use the
(+) or (-) button to adjust the
duty ratio.
"-3" :Brake application time becomes shortest. (Brakes lock with difficulty)
"+3" :Brake application time becomes longest (Brakes lock easily)
(Remark) For low grip, set at the - side and for high grip, set at the + side.
7
(Steering mixing setup)
Select setting item "STM" by (JOG) button up, down, left or
right operation. Use the (+) or (-) button to adjust the steering
mixing range.
- Sets the range within which the A.B.S. function is performed relative to
steering wheel operation.
8
When ending setting, return to the initial screen by pressing
the (END) button twice (for direct selection, press the (END)
button once).
Duty ratio (DTY)
-3 ~ 0 ~ +3
Initial value; 0
Steering mixing (STM)
OFF, N10 ~ N100, E10 ~ E100
Initial value; OFF
Use SW1, SW2, SW3 to switch the A.B.S. function ON/OFF.
See the function select switch function (See page 79).
Switch setting
The brake return amount (ABP), delay amount (DLY) and cycle (CYC) can be con-
trolled with digital dial DL1, DL2, DL3 or digital trim DT3 etc. with the function select
dial function. (See page 80)
Dial / Trim Setting