Futaba 3PKS - Manual (Page 111)

111
Refer
e
nce
Battery Holder (Transmitter)
This battery holder is necessary when using the transmitter with a dry cell battery.
For a description of how to install the battery holder to the transmitter, see "Ni-cad Re-
placement" on page 18.
CAMPac-16K
When the CAMPac-16K is used, the model data for ten model can be saved, in addition
to the ten model memories provided with the transmitter. Since the CAMPac-16K can be
freely carried as a separate unit, the saved data can also be used with other T3PKS trans-
mitters. Do not use any removable memories other than CAMPac-16K.
(Penlight cell x 8)
Part name
T3PK transmitter battery holder
Turn on the power switch and check the
LCD battery voltage display. When the bat-
teries are new, the voltage should be about
12V.
If the voltage does not rise, check for faulty
contact or incorrect polarity.
The method of processing used dry cell bat-
teries depends on the area in which you re-
side. Process the batteries in accordance with
the processing method for your area.
ｉ Caution
ｇ Do not use commercial AA size Ni-cd
and Ni-MH batteries.
Quick charging may cause the battery contacts
to overheat and damage the battery holder.
ｅ Insert the batteries in the correct polarity.
If the polarity is incorrect, the transmitter may be
damaged.
ｅ When the transmitter is not in use,
remove the batteries.
If the battery electrolyte leaks, wipe off the case
and contacts.
Part name
CAMPac-16K