Futaba 3PKS - Manual (Page 101)

CUTION!
NOW MOD OFF
101
F
u
nction
At setup, "NOW ACTIVE" blinks
and a signal is output in the
setup mode.
A bar graph linked with throttle
operation is displayed
Execute ESC setup in accordance with the instruction
manual supplied with the ESC.
If the power switch is not turned off, this setup ESC mode
cannot be reset. If returned to the initial screen in this
setup mode, a blinking message like that shown below
will appear.
HRS ESC setup "MCSET"
1
(Transmitter and ESC connection)
Connect the transmitter and ESC in accordance with the
connection diagram on the preceding page.
2
(ESC setup)
Press the (+) and (-) buttons simultaneously for at least 1
second.
- "NOW ACTIVE" appears on the screen, and a special signal for ESC
adjustment is output from the transmitter DSC terminal. In this state, the
ESC can be adjusted.
ESC adjustment
3
When ending setting, return to the initial screen by pressing
the (END) button twice (for direct selection, press the (END)
button once).