Futaba 3PKS - Manual (Page 23)

Changing wheel position and modifying for left-hand use
23
B
e
fo
re
Using
Total timer
The total timer shows the accumulated time from last reset.
The total time does not change even when the model changes.
Reset method
1
In the initial screen state, hold down the (+) and (-) buttons simultaneously for 1 second.
* The total timer display counts up from 1 minute to 99hours 59 minutes.
In the following cases, the LCD may become difficult to read due to a temperature
change.
- On hot summer days and cold winter days, the LCD may be easy to read indoors, but difficult to read out-
doors.
- If the contrast is too bright or too dark, temperature changes and lighting conditions may cause the screen to
become difficult to read.
LCD Screen Temperature Change
LCD Screen Contrast
The LCD screen contrast can be adjusted. (For more information, see page98.)
Caution
Do not adjust the contrast so that the LCD is too bright or too dark.
When the display cannot be read due to a temperature change, data cannot be set.
Contrast adjustment when no longer called
1
Turn on the transmitter.
2
If the screen is too dark, adjust the contrast by pressing the (-) button while
pressing the (JOG) button. If the screen is too light, adjust the contrast by press-
ing the (+) button while pressing the (JOG) button.
Changing the wheel position
The wheel position can be offset by using the accessory APA
wheel position offset adapter.
(See the next page for the modification method.)
Angle can be adjusted
The angle can be fine adjusted by adjusting the steering wheel unit installation. (See the
modification method on the next page for the adjustment details.)
Modifying for left-hand use
The wheel section left and right installation direction can be re-
versed.
(See the next page for the modification method.)