KEYENCE XG VisionTerminal - Manual (Page 42)

Operation Menu
4-10
Operation Menu
This section explains the commands on the [Operation]
menu.
This procedure connects the XG Series controllers that are
registered as connections in the XG VisionTerminal.
Click [Connect All] from the [Operation] menu.
When the connection is completed, icons for each
connection in the system view change from to
.
Note
• If any of the connections fail, a confirmation screen will appear.
• When multiple connections are registered, it is not possible
select individual controllers to connect to, all of them will be
connected.
This command disconnects all connected XG Series
controllers.
From the [Operation] menu, click [Disconnect All].
When all connections are disconnected, icons for
each connection in the system view change from
to .
Note
• A confirmation screen will appear if logging is in progress.
• When multiple connections are registered, it is not possible
select individual controllers to disconnect, all of them will be
disconnected.
This procedure starts logging data from the XG Series
connected and specified as a logging target.
Note
To store images and archived data output from the XG-8000
Series as logs, Ver. 5.0 or higher is required.
From the [Operation] menu, click [Start Logging].
Logging starts and the logging icon in the system view
changes from to .
Specifying the XG Series controller as a
logging target
Remove the check mark be clicking [Enable Logging]
from the shortcut menu displayed by right-clicking
those connections in the system view you wish to
exclude from logging.
The specified XG Series controllers are excluded as
logging targets.
Reference
By default, all controllers have a check mark and are set as
logging targets.
Setting a connection as a logging target
From the shortcut menu displayed by right-clicking the
desired connection, click on [Enable Logging] to restore
the check mark.
This command stops logging data from all controllers for
which logging is in progress.
From the [Operation] menu, click [Stop Logging].
Logging stops and the logging icon in the system view
changes from to .
Note
It is not possible to stop logging on only a selected controller, all
logging will be stopped.
Reference
Logging will stop the moment the connection is excluded as a
logging target. To resume logging, specify it as a logging target,
then click [Start logging].
Connecting to All Registered XG
Series controllers (Connect All)
Disconnecting the Connected XG
Series Controllers (Disconnect All)
Starting Logging (Start Logging)
Stopping Logging (Stop Logging)