KEYENCE XG VisionTerminal - Manual (Page 37)

View Menu
4-5
XG
Vi
si
on
Te
rmi
na
l
Ap
pl
ic
ati
o
n
Men
u
Using the handheld controller view
Target
Select the connected XG Series to operate.
Arrow buttons
Clicking the arrow buttons navigates through the screen in
the same way the 8 way button on the handheld controller
does.
Buttons 0 to 8
These buttons perform the same function as the 0 to 8
buttons on the handheld controller.
Functions assigned to each button number are listed to the
right of the number.
H button
This button is used to enter key combinations with the
function key.
Click the H button next to buttons 1 or 7 then click the other
button to simulate the key combination on the handheld
controller.
Reference
• You can also send keystrokes using the keyboard or joypad. To
do this, change the button assignments in the [Options] menu
(Page 4-13).
• If multiple remote desktop windows are open, you can change
the operating target for the console view as follows.
- Select the operating target from the drop down list at the top
of the console view.
- From the [View] menu, click the [(XG Series controller to
operate)] and then [Capture console operation focus].
Button numbers for each input device
Button numbers on the console
Each button on the console corresponds to the numbers
shown below.
Button numbers when using a joypad
Each button on the joypad corresponds to the numbers
shown below by default (example using an Elecom joypad
JC-U2410TBK).
USB joypads tested by KEYENCE
• Elecom:
Model: JC-U241-TBK
• Sanwa Supply:
Model: JY-P68US
• Logicool:
Model: GPX-200
Note
Other joypads that have not been tested by KEYENCE may not
function correctly.
FUNCTION TRIGGER
ESCAPE
VIEW
SCREEN MENU
(0)
(7)
(8)
(3)
(6)
(2)
(1)
(4)
(5)
(6)
(5)
(4)
(0)
(5)
(2)
(3)
(7)
(1)