KEYENCE XG VisionTerminal - Manual (Page 20)

Connecting to the XG Series
2-8
Connecting to the XG Series
After connecting the PC with XG VisionTerminal installed
and a XG Series controller, the controller must be
registered as the connection.
Check the following settings.
Settings on the PC
Set the information required for the Ethernet connection (IP
address, Subnet mask, Port number, etc.). For more
details, see the PC and XG Series manuals.
Settings on the XG Series
Start up the XG Series controller and verify the Ethernet
settings are correct. For details, see the user manual for
the XG series that will be used.
Connect the XG Series directly to the PC using an Ethernet
cable (cross cable: OP-66843).
Connecting to the XG Series
Connect the Ethernet cable (cross cable: OP-66843) to
the Ethernet ports on the XG Series controller and the
PC.
Registering the XG Series in the XG
VisionTerminal
The XG Series must be registered as a connection so that
the XG VisionTerminal can recognize it.
1
From the [Connections] menu, click [Add Connection].
The [Add Connection] menu appears.
2
Select [Search for Connections/Controllers].
Before Connecting
Ethernet (1:1) Connection
Ethernet connection