KEYENCE XG VisionTerminal - Manual (Page 41)

Connections Menu
4-9
XG
Vi
si
on
Te
rmi
na
l
Ap
pl
ic
ati
o
n
Men
u
Connections Menu
This section explains the commands on the [Connections]
menu.
1
From the [Connections] menu, click [Add
Connection].
The [Add Connection] menu appears.
2
Specify the XG Series controller to register it as a
connection.
For a USB connection
Click [USB].
For an Ethernet connection
Select [Search for Connections/Controllers], and then
click [Search]. The XG Series connected to the PC
appears in the list. Check the box next to the XG
Series controller you wish to register as a connection.
Note
Clicking [Search] will only display controllers that exist in the
same subnet.
Reference
To register an XG Series controller that does not display as
connected to the network, click [IP address] and manually
enter the IP address of the connected controller.
3
Click [OK].
The new connection is added and appears in the
connection view.
Deleting connections
Note
Always disconnect the connection before deleting it.
1
Click [Delete connection] from the shortcut menu
displayed by right-clicking on the connection in the
connection view.
A confirmation screen appears.
2
Click [Yes].
The XG Series controller selected in Step 1 is deleted
from the list of connections. Click [No] to exit without
deleting the connection.
Registering a New Connection
(Add Connection)