KEYENCE XG VisionTerminal - Manual (Page 23)

Connecting to the XG Series
2-11
Pr
epa
rations
1
Connect the XG Series to the PC using the optional
USB cable (OP-66844).
[Found New Hardware Wizard] will appear on the PC
screen.
2
Select "No, not this time", and click [Next].
3
Select [Install from the list or specified location]
and specify the folder that contains the USB driver.
Installation of the USB driver starts.
Reference
• The USB driver is stored in \driver\USB in the enclosed CD-
ROM. Note, this driver is also installed in the [c:\drivers\V-
Works for XG] (For Ver. 5.
∗, c:\drivers\V-Works for XG H8N)
following installation of the XG VisionTerminal.
• When you install a driver in the Windows XP environment,
Windows may display a warning message. When a
warning message appears, click [Continue] to complete
the driver installation.
4
When the USB driver installation is completed,
click [Finish].
The XG Series and PC are now connected through the
USB.
Registering the XG Series in the XG
VisionTerminal
The XG Series must be registered as a connection so that
the XG VisionTerminal can recognize it.
Note
Only one XG Series can be registered as a USB connection.
1
From the [Connections] menu, click [Add Connection].
The [Add Connection] menu appears.
2
Click [USB].
3
Click [OK].
The new connection is added and appears in the
system view.