KEYENCE XG VisionTerminal - Manual (Page 30)

Logging Data from the XG Series
3-6
Logging Data from the XG Series
The XG VisionTerminal can log (collect) inspection results,
images, and archived data output from the XG Series
during operation.
Note
• To log data, the flowchart program created in XG VisionEditor
must include either a data output step, an output image step, or
an archived output location step that specifies the [PC
program] as the destination device. For more details, see the
XG VisionEditor Reference Manual (Programming Edition).
• To store images and archived data output from the XG-8000
Series as logs, Ver. 5.0 or higher is required.
Register the XG Series controller as a connection in the XG
VisionTerminal to log data from it.
1
From the [Connections] menu, click [Add
Connection].
The [Add Connection] menu appears.
2
Specify the XG Series controller to register it as a
connection.
For a USB connection
Click [USB].
For an Ethernet connection
Select [Search for Connections/Controllers], and click
[Search]. The XG Series connected to the PC appears
in the list. Check the box next to the XG Series
controller you wish to register as a connection.
Note
• Clicking [Search] will only display controllers that exist in
the same subnet.
• When there are multiple controllers connected to the
network, some of them may not show up initially. Repeat
the search as necessary.
Reference
To register an XG Series controller that does not display as
connected to the network after searching, click [IP Address]
and manually enter the IP address.
3
Click [OK].
The new connection is added and appears in the
system view.
1. Registering a Controller