KEYENCE XG VisionTerminal - Manual (Page 13)

2-1
Chapter
Pr
epa
rations
2
Preparations
Installing the XG
VisionTerminal
Installation procedures will differ depending on whether
the program is being installed from the CD-ROM or by
downloading from the User Support page.
Reference
This example below explains the installation procedures for
Windows XP.
Install the XG VisionTerminal from the CD-ROM by using
the following procedures.
Note
• If the PC you are installing to does not have the necessary
runtime components used by this software, you will be asked to
install those components. Follow the instructions and install all
components as necessary.
• Do not connect the USB cable to the PC and XG Series
controller prior to installation.
• Installation must be performed by a user with Administrator
privileges.
• Uninstall any previous version of this software (Page 2-3).
• When installing on a notebook PC, be sure to connect the AC
adapter power supply.
1
Insert the XG-H7N or XG-H8N CD-ROM into the CD-
ROM drive of the PC.
The installation guide appears.
Reference
If the installation guide does not appear, double-click
\XG\VisionTerminal\setup.exe located on the CD-ROM.
2
Click [Install XG VisionTerminal Ver.[the version the
will be installed]].
The installer launches and the [Installer Language]
appears.
Reference
If the installer does not appear, double-click setup.exe in the
CD-ROM menu.
New Installation from the CD-ROM