KEYENCE XG VisionTerminal - Manual (Page 26)

Controlling the XG Series Remotely (Remote Desktop)
3-2
Controlling the XG Series Remotely
(Remote Desktop)
View the monitor output from the XG Series controller in XG
VisionTerminal.
Note
XGA image output is not supported in Ver. 4.
∗.∗∗∗.
Register the XG Series controller as a connection in the XG
VisionTerminal to view the screen output.
1
From the [Connections] menu, click [Add
Connection].
The [Add Connection] menu appears.
2
Specify the XG Series controller to register it as a
connection.
For a USB connection
Click [USB].
For an Ethernet connection
Select [Search for Connections/Controllers], and then
click [Search]. The XG Series connected to the PC
appears in the list. Check the box next to the XG
Series controller you wish to register as a connection.
Note
• Clicking [Search] will only display controllers that exist in
the same subnet.
• When there are multiple controllers connected to the
network, some of them may not show up initially. Repeat
the search as necessary.
Reference
To register an XG Series controller that does not display as
connected to the network after searching, select [IP Address]
and manually enter the IP address.
3
Click [OK].
The new connection is added and appears in the
system view.
1. Registering a Controller