Welch Allyn Duet CO2 Module - User Manual - Manual (Page 94)

Duet CO
2
Module OEM Implementation Manual
Page 94 Confidential Welch Allyn OEM Technologies
Initial Setup
To connect the hardware and start the program:
1. Plug the Serial Cable’s male connector into the 9 pin D-Type Serial jack on the back panel of the
CO
2
Module Evaluation Platform.
2. Plug the Serial Cable’s female connector into the Computer’s Serial Port 1 (CommPort 1).
3. With the Power Supply’s AC cord unplugged, connect the Power Supply’s other plug into the
power jack on the back of the CO
2
Module Evaluation Platform.
4. Plug the Power Supply’s AC cord into a 110 VAC wall outlet (or 220 VAC depending on
transformer configuration and available AC power).
5. At the computer, locate the CO2Mon Program directory created during the installation process, and
click on the CO2Mon icon to start the program.