Welch Allyn Duet CO2 Module - User Manual - Manual (Page 93)

Duet CO
2
Module OEM Implementation Manual
Welch Allyn OEM Technologies Confidential Page 93
CO2 Developer’s Kit
Introduction
The CO
2
Developer’s Kit provides hardware and software to simulate a monitoring system
capable of measuring and displaying real-time carbon dioxide measured in a patient’s
exhaled breath. The system also displays breath parameters such as end-tidal CO
2
, inspired
CO
2
, and respiration rate. The following items make up the CO
2
Developer’s Kit:
• CO
2
Module (LC-101 or Duet)
• CO
2
Module Evaluation Platform
• Evaluation Platform Power Supply
• Serial Cable (9pin D-Type)
• CO
2
Monitor Windows Software (CD) operating on a PC with these minimum
requirements: 200 MHz Pentium, 32MB of RAM, 10MB of hard drive space.
NOTE: Several different versions of the CO
2
Developer’s Kit are available depending on the
customer requirements. Contact Welch Allyn OEM Technologies for more information.
Disclaimer
The CO
2
Evaluation System does not have regulatory approval and is not intended for clinical
use. It is only intended as an engineering evaluation tool.
Software Installation
To install this software on a Windows 95/98/NT computer, do the following:
1. Insert the CO
2
Monitor Windows Software CD into the computer’s CD-ROM drive.
2. Follow the screen instructions to install the software.
If the CO
2
Monitor software setup program does not start automatically, follow these
steps:
1.
Open My Computer, Windows Explorer, or File Manager.
2. Double click on the CD drive letter (usually D:,E:, or F:).
3. Double click Setup.exe.
4. Follow the screen instructions to install the software.