Welch Allyn Duet CO2 Module - User Manual - Manual (Page 35)

Duet CO
2
Module OEM Implementation Manual
Welch Allyn OEM Technologies Confidential Page 35
STATUS (bits 7, 6, 5 ) MODE see below
bit 7* bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
Status X, Mode x
SXx
hrdwr for ms
(in 1, out 0)
hrdwr for ss
(in 1, out 0)
module in
(ss 1, ms 0,)
8 4 2 1 8 4 2 1
S 0x 0 0 0 0 0 x x x
S 2x 0 0 1 0 0 x x x
S 4x 0 1 0 0 0 x x x
S 6x 0 1 1 0 0 x x x
S 8x 1 0 0 0 0 x x x
S Ax 1 0 1 0 0 x x x
S Cx 1 1 0 0 0 x x x
S Ex 1 1 1 0 0 x x x
* to set bit 7-both the mainstream sensor and mainstream stick must be present
**bits 3 & 4 are always zero as there are only 5 Modes (values 6 - 31are undefined)
Mode Table
Mode Status x, Mode X bit 2 bit 1 bit 0
SxX (4) (2) (1)
Standby S x1 0 0 1
Warm-up S x2 0 1 0
Measurement S x3 0 1 1
Autorun S x4 1 0 0
Fault S x5 1 0 1
Status Response Message Byte
yy> where yy = Status Message (2Hex digits = 2 ASCII characters)
Status message byte (yy) contains
§ generic status messages (00h – 06h)
§ fault status messages (10h – 85h)
Refer to the Status Message Code Table at the end of this section for message descriptions. More
detailed information about fault messages is also available in the Appendix - Error Messages &
Recovery.