Elecraft KDSP2 Manual - Manual (Page 19)

19
3-Volt Lithium Cell Installation
Turn the K2 off.
The (+) side of the 3-volt cell must be oriented towards the DSPx module. The (-) side must face the left
side panel of the K2.
i
DO NOT use long-nose pliers to hold the Lithium cell! Doing so will short the + and - sides
together.
In the following step, be careful to not stress the spring clip when inserting the cell, or it may not make
good contact with the cell.
Insert the Lithium cell into its socket, under the spring clip.
The Operation section of this manual describes the procedure to set the clock and calendar.