AVer NX8000 - Manual (Page 68)

61
- Snapshot
Take a snapshot when the alarm is activated.
a. Select Camera: specify which channel video to be snapshot when the alarm is
occurred.
-
Alarm Camera: when a channel has an alarm occurred, and then, the DVR
system will snapshot the channel video.
- Camera # (1~32):
the selected channel would be snapshot when an alarm is
occurred.
b. Video Size: select the size of snapshot picture.
c. Number of picture: the number of picture that is going to be taken.
d. Snapshot Interval: a time gap for next snapshot
e. Save Path: a storage path for saving snapshot pictures.
f. Delete image after: set a certain amount of snapshot image storage limit. When
the snapshot image is over the limit, and then, the system will start recycle the
snapshot image.
5.9.1 To Setup Alarm Relay:
1. Beside the Relay Output check box, click Detail.
2. In the Alarm Relay dialog box, select from the available relay list and in the ON column,
set to enable/disable the relay operation when the alarm is activated.
In the Retrieve time check box, you may enable/disable to extend the relay operation time
and set the duration in second.
3. Click OK to exit and accept the setting and Cancel to exit without saving the setting.