AVer NX8000 User Manual
Page 67
60
additional time in second before it stops the relay operation (see also
).
-
IP Camera Relay
Set to enable/disable IP camera relay trigger. Click ON column to enable/disable the
relay trigger. The blank column means the trigger is off.
-
Play Warning Sound
Play alarm sound. To setup click Detail (see also
-
Make Phone Calls
Dial and contact the number in the list. To setup click Detail (see also
To use this feature, the PC must have a voice modem connected to it. The supported
audio system is only 8KHz and 16Bit mono.
-
Send E-mail
Send an electronic text message. To setup click Detail (see also
).
-
File Transmission via FTP
Upload file to remote computer thru FTP (File Transfer Protocol). To setup click Detail
(see also
-
Start Recording
Record the video from the selected camera. To setup click Detail (see also
-
SMS (Short Message Service)/MMS (Multimedia Messaging System)
SMS transmits only text messages to mobile phone. MMS transmits text messages
and images over wireless networks using the wireless application protocol (WAP).
Make sure your mobile phone support this feature and your PC is connected to
GSM/GPRS modem. To setup click Detail (see also
).
-
PTZ preset point
Position the PTZ camera based on the preset point setting. To setup click Detail (see
also
).
-
Alarm SOP (Standard Operation Procedure)
List the instructions to inform the person of what to do when the alarm is activated. To
setup click Detail (see also
).
-
Send to CMS (Central Management System)
Enable/disable the selected camera to send video to CMS when the alarm is activated
(see also
-
Launch Program
To call up the external program that is provided by 3
rd
party. Click Detail and click
to locate the program path. Enable Multiple instance check box to allow the program
can be executed multiple times at the same time.