3 recording setting, Recording setting – AVer NX8000 User Manual
Page 52
45
5.3
Recording Setting
In the Recording dialog box, click OK to accept the new settings, click Cancel to exit without
saving, and click Default to revert back to original factory setting.
i
The gray selections are not support for IP camera.
(6)
(7)
(8)
(5)
(1)
(2)
(3)
(4)
(1) Camera Icons
Select the camera number you want to set the recording setting. To select all the cameras,
enable the ALL check box. To select more than one camera, Right click on the camera icon.
To select one camera only, Left click on the camera icon. The camera icon turns red when it
is selected.
(2) Recording Mode
The blocks from 00 to 23 represent the time in 24-hour clock. To record in full 24 hours, select
the recording mode and click the ~ button. If you want to only record at a particular time, click
the colored block beside the recording mode then click on the time blocks. When the system
starts recording a red triangle mark would appear at the upper left corner of the screen. The
recording modes are listed below:
-
Always Recording
Record the video from the selected camera and save it to the designated storage path
(see also
-
Motion Recording
Start recording the video from the selected camera only when the system detects
movement. Once a motion is detected, the system automatically saves the previous
frames and stop based on the Start Record Prior and Stop Record After settings.
-
Smart Recording
Automatically switch to recorded at the maximum frame rate setting once a motion is
detected and if there is no motion, it records at the minimum frame rate setting. Set the
maximum frame rate setting in
-
No Recording
The
system won’t do any recording.
(3) Motion Detection
Adjust the sensitivity of the motion detector. The higher the value, the finer the sensitivity is