AVer NX8000 User Manual
Page 65
58
condition for the system to alarm, click High or Low column. The column with a circle
means is selected.
- Enable/disable
the
Abnormal Event
check box, to set the condition of the event for
system to alarm.
• Reboot: when the DVR system reboot without abnormal condition, the system
will send out the alarm message.
• Abnormal Reboot: when the DVR system reboot in irregular condition, the
system will send out the alarm message.
• Recording is switched off: when the recording has been stopped, the system
will send out the alarm message.
• Network is switched off: when the network connection of DVR system is lost,
the system will send out the alarm message.
• Hard Disk failed: when the hard disk can’t work normally, the system will send
out the alarm message.
• Temperature: set a temperature limited of system for system to alarm. When
DVR system temperature is over the temperature limited, the system will send
out the alarm. The system supports °C and °F temperature mode.
• Illegal Entry: any objects move between selected regions which user has set up
in Object Counting section (see
), the system will send out the
alarm. Select the entry (object moves from region 1 to 2 or from region 2 to 1)
and camera for system alarm detection.
i
Only the camera has been setup in Object Counting will be available
for selecting in Illegal Entry.
- Enable/disable
the
POS Keyword
check box, to scan the data from the POS if it
matches the keyword (see also
).