4 network setting, Network setting – AVer NX8000 User Manual
Page 55
48
5.4
Network Setting
In the Network Setting dialog box, click OK to accept the new settings, click Cancel to exit
without saving, and click Default to revert back to original factory setting. For the network
service ports that use by DVR server, please see
.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(1) Server Name
Assign a name for the DVR unit. Alphabet letters and numbers only.
(2) Transmitting Cameras
Select and click on the camera number in the Transmitting Camera section you want to make
it accessible via internet using WebViewer, Remote Console, PDA Viewer and Hand Viewer
(still image). To select all the cameras, enable the ALL check box.
(3) Main Configuration
Set the Server IP and Remote Console Port number. The system will automatically detect your
Server IP address. You need this when accessing DVR server from the remote location via
internet.
(4) Dynamic DNS (Domain Name System)
Enter the Domain Name and Password. To use this feature, go to http://
and register.(also see
) You will be prompted to enter CD key number, product
name, password, and user information. Use this service if the IP address changes each time
when you connect to internet.
(5) Remote Control Server
Enable/disable remote control from remote application (ex. CM3000). Enter the remote
accessing port in Port column. The default value is 5555.
i
User also can manually run this function. To run, click Start > Programs > DSS >
Tool > Remote Control Server. The
remote control server icon appears on the
taskbar when the remote control server is enabled. (also see
(6) Network Video Configuration
Set up the video quality and frame rate for viewing and transmitting to the remote program.
Scrolling adjust bar to set the Quality level and FrameRate level.
(7) WebViewer Configuration
Activate Enable Anonymous Login to remotely access the DVR server without the need of
password