AVer NX8000 - Manual (Page 63)

56
11. To view the all I/O devices information, click I/O Map.
5.8 Relay Setting
The I/O device must be installed to use this function.
To set the Relay Setting:
1. Click the drop-down list and select the relay ID number.
2. Enter sensor name.
3. Click
External IO
to configure external I/O device if it is available(see also 5.7.1 )
4. The system automatically detects the card and input number. In the Content section, enter
sensor description.
5. In the test section, click Test to check the relay status. Red is high and Green is low.
6. Click
OK
to exit and accept the setting and Cancel to exit without saving the setting.