AVer IWH5000 series - Manual (Page 73)

65
4.6 To Setup the PTZ/IP PTZ Camera
4.6.1 Setup the PTZ Camera
1. In the PTZ control panel, click Setup.
2. When the PTZ Setup dialog box appears, select the camera number and check the Use PTZ
box.
3. In the Connection Settings section, select the COMPort where the PTZ camera is
connected, PTZ ID number, BaudRate, and Protocol. Then, click Save to keep the settings.
4. Use the PTZ control panel and adjust the position of the PTZ camera.
5. In the Preset Setting section, select the preset number to assign a number for the PTZ
camera current position. Set the DwellTime (1-60 sec) for how long the PTZ camera stays in
that position before it moves to the next one. If you want to add description, check the Show
Preset Name box and in the Preset Name text box, type the word. When done, click Save to
keep the settings.
i
- The numbers of preset position are depended on the IP camera protocol has
supported.
- Only Pelco-P and Pelco-D protocol can support over 16 PTZ preset points.
- Only Canon
has supported “Auto Pan Speed” function.
Using this control
panel to set the
preset position