Canon FAX-L1000 - Manual (Page 81)

2-25
FAX-L1000 Chapter 2: Operating Instructions
*1 : OK, NG messages
*2 : Indicates four digits of the transaction number
*3 : Number sent from the other party or number dialled (lower 20 digits)
*4 : ID sent from the other party, if the other party is a Canon fax
*5 : Communication start date and time (on 24-hour display)
*6 : Communication time (in minutes and seconds)
*7 : Number of pages for which transmission was complete
*8 : “NG” display with number of pages for which transmission was fault, and service
error code
*9 : Communication start date and time (on 24-hour display)
*10 : Telephone number sent from other party
*11 : Maker code
*12 : Machine code
*13 : Received V.8 protocol signal
*14 : Symbol rate used for the primary channel
*15: Transmission speed used for the primary channel
*16 : 0 (Fixed)
*17 : Code output by the modem when an error occurred
(Not used in the field)
*18 : Transmit status of the modem when an error occurred
(Not used in the field)
*19 : Receive status of the modem when an error occurred
(Not used in the field)
*20 : Bit 1 to bit 96 of received DIS, DCS, or DTC
*21 : Bit 1 to bit 96 of transmitted DIS, DCS, or DTC
*22 : RX=Received protocol signal
TX=Transmitted protocol signal