Canon FAX-L1000 - Manual (Page 326)

4-74
FAX-L1000 Chapter 4: Maintenance and Service
h) Recording paper pickup error
The recording paper is not picked up from the multi-purpose tray
Solution: (1) Check that the recording paper is not curled and is set correctly.
(2) Check if more than the regulation amount of recording paper is loaded
in the multi-purpose tray.
(3) Clean the multi-purpose tray pickup roller.
(4) Check the pickup solenoid, pickup solenoid connector (J125, J126)
and ECNT board (J56) connections.
(5) Check the resistance between multi-purpose tray pickup solenoid
(J126-2) and (J126-3), which should be approx. 110 ohm. If it is not,
replace the multi-purpose tray pickup solenoid.
(6) Check if the gears of the multi-purpose tray pick-up unit is not
damaged.
(7) Replace the multi-purpose tray pickup roller.
(8) Replace the separation pad.
(9) Replace any damaged gears of the multi-purpose tray pick-up unit.
(10) If the FAX-L1000 Printer Kit is installed, make a test print from the
multi-purpose tray. If the paper is picked up correctly, replace the
FAX-L1000 Printer Kit.
(11) Replace the ECNT board.
Recording paper is not picked up from the cassette 1
Solution: (1) Check that the cassette 1 is installed correctly.
(2) Check if more than the regulation amount of recording paper is loaded
in the cassette 1.
(3) Check that the cassette pickup roller is at its initial position. If it is not,
after switch the power on, insert the cassette 1 into the main unit.
(4) Clean the cassette pickup roller, cassette feed roller and cassette
separation roller.
(5) Check the cassette claw. If it is deformed, replace it.
(6) Check the cassette pickup solenoid and paper size detection board 1
(J604) connections.
(7) Check the resistance between cassette pickup solenoid (J604-1) and
(J604-2), which should be approx. 110 ohm. If it is not, replace the
cassette pickup solenoid.
(8) Check the pick-up module drive unit. If there are damaged parts,
replace any damaged parts.
(9) Check the ECNT board (J72) and paper size detection board 1 (J603)
connections.
(10) Replace the cassette pickup roller.
(11) Replace the cassette feed roller and cassette separation roller together.
(12) If the FAX-L1000 Printer Kit is installed, make a test print from the cassette
1. If the paper is picked up correctly, replace the FAX-L1000 Printer Kit.
(13) Replace the paper size detection board 1.
(14) Replace the ECNT board.