Canon FAX-L1000 - Manual (Page 301)

4-49
FAX-L1000 Chapter 4: Maintenance and Service
No. Tx or Rx Definition
##0290 [ TX ] Receive signals other than PIN, PIP, MCF, RTP
or RTN after MPS transmission
• Printer error codes
No. Tx or Rx Definition
New ##0322 [ RX ] Printer (LBP) fixing unit trouble
New ##0323 [ RX ] Printer (LBP) BD (Beam Detect) trouble
New ##0324 [ RX ] Printer (LBP) scanner trouble
New ##0325 [ RX ] Printer (LBP) main motor trouble
• V.8/V.34 protocol error codes
No. Tx or Rx Definition
New ##0670 [ TX ] At V.8 late start, the called party declares the V.8
protocol in DIS signal and this unit transmits a CI
signal, but the protocol does not progress and a T1 time-
out occurs.
New ##0671 [ RX ] At V.8 termination, the protocol did not advance to
phase 2 and a T1 time-out occurs after the caller CM
signal was detected.
New ##0672 [ TX ] The protocol did not move from phase 2 to phase 3 and
a T1 time-out occurred during V.34 transmission.
New ##0673 [ RX ] The protocol did not move from phase 2 to phase 3 and
a T1 time-out occurred during V.34 reception.
New ##0674 [ TX ] The protocol did not move from phase 3 to phase 4 and
a T1 time-out occurred during V.34 transmission.
New ##0675 [ RX ] The protocol did not move from phase 3 to phase 4 and
a T1 time-out occurred during V.34 reception.