Canon FAX-L1000 User Manual
Page 300
4-48
FAX-L1000 Chapter 4: Maintenance and Service
No.
Tx or Rx
Definition
#0995
[ TX/RX ]
The image data stored in memory have been cleared
c-2) Service error codes
• G3 mode error codes
No.
Tx or Rx
Definition
##0100
[ TX ]
Excessive repeat protocol during transmission
##0101
[ TX/RX ]
Modem speed different from other party
##0102
[ TX ]
Fall back failure during transmission
##0103
[ RX ]
Fail to detect EOL for 5 seconds (15 seconds for CBT)
during reception
##0104
[ TX ]
RTN or PIN received during transmission
##0106
[ RX ]
Fail to receive protocol for 6 seconds when waiting for
protocol during reception
##0107
[ RX ]
Fall back failure on transmission side during reception
##0109
[ TX ]
Receive signals other than DIS, DTC, FTT, CFR or
CRP after DCS Tx and exceed the number of protocol
re-transmissions during transmission
##0111
[ TX/RX ]
Memory error
##0114
[ RX ]
RTN transmission during reception
##0116
[ TX/RX ]
Detect loop current disconnection during
communication
##0200
[ RX ]
Fail to detect picture reception carrier for 5 seconds
during reception
##0201
[ TX/RX ]
DCN reception other than normal binary protocol
##0223
[ TX ]
Line disconnected during communication
##0224
[ TX/RX ]
Abnormal protocol during G3 communication
##0229
[ RX ]
Recording unit locked for 1 minute
##0232
[ TX ]
ENCODE control unit malfunction
##0237
[ RX ]
DECODE control unit malfunction
##0238
[ RX ]
PRINT control unit malfunction
##0261
[ TX/RX ]
System error between MODEM and SCNT
##0280
[ TX ]
Excessive repeat protocol command during transmission
##0281
[ TX ]
Excessive repeat protocol command during transmission
##0282
[ TX ]
Excessive repeat protocol during transmission
##0283
[ TX ]
Excessive repeat protocol during transmission
##0284
[ TX ]
DCN reception after TCF transmission
##0285
[ TX ]
DCN reception after EOP transmission
##0286
[ TX ]
DCN reception after EOM transmission
##0287
[ TX ]
DCN reception after MPS transmission
##0288
[ TX ]
Receive signals other than PIN, PIP, MCF, RTP or RTN
after EOP transmission
##0289
[ TX ]
Receive signals other than PIN, PIP, MCF, RTP or RTN
after EOM transmission