Palm rest, Removing the palm rest – Dell Latitude E4300 (Late 2008) User Manual
Page 43
Back to Contents Page
Palm Rest
Dell™ Latitude™ E4300 Service Manual
Removing the Palm Rest
1.
Follow the instructions in
What You Need to Know For Your Safety
.
2.
Remove the LED dashboard cover (see
Removing the LED Dashboard Cover
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the display assembly (see
Removing the Display Assembly
).
5.
Turn the computer upside-down and remove the two M2 x 3-mm screws and two M2.5 x 8 screws from the bottom of the computer.
6.
Turn the computer rightside-up and remove the five M2.5 x 5-mm screws and five M2.5 x 8-mm screws from the top of the palm rest.
7.
Disconnect the seven cables connecting the palm rest to the system board, as shown in the illustration below.
CAUTION:
Before you begin the following procedure, follow the safety instructions that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
1 M2.5 x 5-mm screws (5; small arrows) 2 M2.5 x 8-mm screws (5; large arrows)